
5
10- Continue running the S&S® wiring harness so the four wire ends are directly next to the 36-position ECM connector and fuse block area. Cut
the wire tie at the base of the main wiring harness where it meets with the 36-position gray connector. See Picture 7, below.
11- Carefully open the backside of the 36-position connector housing. See Picture 8, below.
12- Gently release the clips on each side of the clear plastic cover on the 36-position connector by pressing on each clip with a small at
screwdriver as shown in Picture 9, below.
Picture 7
Picture 8
Picture 9
Commenti su questo manuale